Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
| doku:cfd [2021/10/22 06:03] – [Submit job] sfrank | doku:cfd [2021/10/22 06:11] – [Using a shared node] sfrank | ||
|---|---|---|---|
| Line 315: | Line 315: | ||
| If your case isn't that demanding on hardware and you are interested in a fast solution, it is possible to use one of the shared nodes. These are non-exclusive nodes, thus more than just one job is able to use the provided hardware. | If your case isn't that demanding on hardware and you are interested in a fast solution, it is possible to use one of the shared nodes. These are non-exclusive nodes, thus more than just one job is able to use the provided hardware. | ||
| On these nodes you have to tell SLURM, how much memory (RAM) your case would need. This value should be less than the maximum of 96GB these nodes uses. Otherwise your job needs a whole node anyway. | On these nodes you have to tell SLURM, how much memory (RAM) your case would need. This value should be less than the maximum of 96GB these nodes uses. Otherwise your job needs a whole node anyway. | ||
| + | Here we use --mem=20G, to dedicate 20GB of memory. | ||
| < | < | ||
| Line 331: | Line 332: | ||
| module load Comsol/5.6 | module load Comsol/5.6 | ||
| module list | module list | ||
| - | . | ||
| - | . | ||
| . | . | ||
| . | . | ||